Pine Straw Calculator: How Many Bales Do I Need?
A typical bale of pine straw covers about 35 to 50 sq ft at 2 to 3 inches deep. Divide your bed area by the coverage per bale and add about 5%. At 40 sq ft per bale, 1,200 sq ft of beds needs 32 bales, and new beds laid thicker need about half as much again.
Pine straw calculator
How Many Bales
- Measure the bed area in square feet, excluding plants and hardscape you will not cover.
- Bales = area / coverage per bale.
- Add about 5% for fluffing, edges and gaps.
- For new beds or a heavier look, allow roughly 1.5 times as much.
Coverage depends on the bale. Square bales from different suppliers vary in weight and needle length, so the calculator lets you enter your supplier figure. Without one, 40 sq ft per bale is a sensible middle value.
Worked Example
- 1,200 sq ft of beds at 40 sq ft per bale = 30 bales.
- Plus 5% = 31.5, so buy 32 bales.
- A new bed laid extra thick: about 1.5 x 30 x 1.05 = 48 bales.
Spreading Pine Straw
- Shake each bale apart and spread to 2 to 3 inches after it settles.
- Tuck the edges under along borders for a clean line.
- Keep it a few inches back from house siding and away from heat sources; dry pine straw burns readily.
- Top up each year with roughly a third to half of the original amount as it breaks down.
Measure all your beds from satellite in one go, then compare with mulch using the mulch calculator.
Sources
Frequently Asked Questions
How many square feet does a bale of pine straw cover?
Usually about 35 to 50 sq ft at 2 to 3 inches deep, depending on the bale size and needle length. Ask your supplier for their figure.
How many bales of pine straw per 1,000 square feet?
About 20 to 29 bales per 1,000 sq ft for a standard layer, or roughly 26 at 40 sq ft per bale with 5% extra.
Is pine straw better than mulch?
Pine straw is lighter, cheaper to spread over large areas, and stays put on slopes, but it breaks down faster and needs topping up yearly. Wood mulch lasts longer and suppresses weeds a little better.