Lime Calculator: How Much Lime Per 1,000 Sq Ft?

To raise lawn soil from pH 5.5 to about 6.5, loam soil typically needs around 75 lbs of pure lime per 1,000 sq ft, sandy soil about 45 lbs and clay about 100 lbs. Divide by the lime's neutralizing value, and apply no more than about 50 lbs per 1,000 sq ft at a time.

Lime calculator

Enter your area to see how much to order.
Estimate to raise pH to about 6.5. On an established lawn, apply no more than about 50 lbs per 1,000 sq ft at a time. A soil test with a lime recommendation is always more accurate than an estimate.
Don't know your area?Measure it from satellite, free

How Much Lime Raises pH

Lime neutralizes soil acidity. How much you need depends on how acidic the soil is and on its buffering capacity: clay and organic soils resist change, so they need more lime than sand for the same pH shift. The calculator estimates pounds of pure calcium carbonate per 1,000 sq ft to reach about pH 6.5, the range most lawn grasses prefer.

  • pH 6.0: about 20 lbs (sand), 35 lbs (loam), 50 lbs (clay) per 1,000 sq ft
  • pH 5.5: about 45, 75 and 100 lbs
  • pH 5.0: about 65, 110 and 150 lbs

These are typical estimates. A soil test from your state extension service reports a buffer pH and a lime requirement for your actual soil, which beats any table.

Adjusting for the Product

Bags list a calcium carbonate equivalent (CCE) or effective neutralizing value (ENV). A product rated 90% does 90% of the work of pure calcium carbonate, so you need more of it: divide the rate by 0.90.

NPK

Worked Example

A 5,000 sq ft lawn on loam, soil test pH 5.5, lime with an ENV of 90%.

  • Base rate: 75 lbs per 1,000 sq ft.
  • Adjusted: 75 / 0.90 = 83 lbs per 1,000 sq ft.
  • Total: 5 x 83 = about 417 lbs, roughly eleven 40 lb bags.
  • Because 83 lbs is above the 50 lb single-application limit, split it into two applications a few months apart.

Applying Lime

  • Fall and early spring are the usual windows; freeze and thaw cycles help work it in.
  • Pelletized lime spreads cleanly through a broadcast spreader. Apply half in one direction and half crosswise.
  • Water lightly after spreading so it moves off the leaves.
  • Retest in 6 to 12 months. pH moves slowly and overliming is hard to undo.

Measure the lawn first so the bag count is right, and pair liming with the fertilizer calculator for the rest of your soil plan.

Sources

Frequently Asked Questions

How much lime do I need per 1,000 square feet?

Usually between 20 and 150 lbs of pure lime per 1,000 sq ft, depending on how acidic the soil is and whether it is sand, loam or clay. A pH 5.5 loam needs about 75 lbs to reach pH 6.5.

Can you put too much lime on a lawn?

Yes. Raising pH above about 7.0 locks up iron and manganese and can yellow the grass, and lowering pH again is slow. Apply no more than about 50 lbs per 1,000 sq ft at a time and retest before adding more.

How long does lime take to work?

Lime starts reacting within weeks, but a full pH change usually takes several months. Finer and pelletized products act faster than coarse agricultural lime.