How to Price Lawn Care by Square Foot
Build a defensible price from measured area rather than a windscreen guess, including the factors that should adjust the rate and the ones that should not.
Most lawn care operators price by looking at a property and deciding what feels right. It works until it does not: the yard that looked small turns out to be half an acre behind the house, the route runs late all season, and the job that felt profitable was subsidising itself out of the other stops.
Pricing from measured area does not remove judgement. It gives the judgement something to adjust from.
Start With a Base Rate
Build the rate from your own numbers rather than a figure from a forum. You need three:
- Your hourly target including labour, equipment, fuel, insurance, overhead and profit
- Your production rate in square feet per hour, measured on real jobs
- Base price per sq ft = hourly target divided by production rate
Example. A two-person crew costing $95 per hour fully loaded, mowing 22,000 sq ft per hour on open turf, gives 95 / 22,000 = $0.0043 per sq ft. A 7,000 sq ft lawn prices at about $30 before adjustments.
Track production rate from actual timed jobs. It is the number that moves most between crews and equipment, and the one operators most often assume rather than measure.
What Justifies an Adjustment
Area sets the baseline. These factors change how long that area actually takes:
- Obstacles. Trees, beds, play equipment and furniture mean trimming rather than mowing. Add 10 to 30%.
- Gates and access. A 36 in gate forces a walk-behind. Add 15 to 25%, more if equipment must be carried.
- Slopes. Anything beyond about 20 degrees is slow and needs different equipment. Add 20 to 40%.
- Edging length. Priced per linear foot of hard edge, not per square foot of turf.
- Fragmentation. Four separate 500 sq ft zones take far longer than one 2,000 sq ft lawn.
- Disposal. Bagging and hauling clippings is a separate line, not absorbed into the mow.
Measuring zones separately rather than as one polygon exposes fragmentation before you quote, which is exactly where windscreen pricing goes wrong.
Minimum Charge Is Not Optional
Below a certain size, per-square-foot pricing stops covering the cost of arriving. Drive time, unloading, setup and pack-up are fixed regardless of lawn size.
- Set a minimum that covers travel plus setup plus a target margin, commonly $35 to $60
- Apply per-square-foot pricing only above the size where it exceeds the minimum
- Route density is what makes small jobs viable. Five small lawns on one street beat one across town.
- Decline work that breaks the route rather than discounting it to fit
Quoting Without a Site Visit
A site visit costs 30 to 60 minutes including drive time. At a typical close rate, that is significant unpaid labour per won job. Measuring from satellite imagery removes most of it.
- Measure the turf area from the address before calling back
- Quote a firm price for what imagery shows clearly, with a stated assumption
- Name the unknowns explicitly: gate width, slope, dog waste, condition at first cut
- Reserve the right to adjust once, on the first visit, and only for those named items
A quote that says what it assumes is more defensible than one that does not, and it is far easier to adjust fairly when the assumption turns out to be wrong.
Quoting Checklist
- Turf area measured, hardscape and beds excluded
- Zones counted separately to expose fragmentation
- Base rate applied from your own production data
- Adjustments applied for obstacles, access, slope and disposal
- Minimum charge checked against the result
- Assumptions stated in writing on the quote
- First visit timed, and production rate updated from it
The operators who stay profitable are not the ones who guess best. They are the ones whose guesses are corrected by measurement every season.